How to Replace a Kastyxa Handle with the Reservskaft

By Adventure tipi tents and giant hat Nordic kata wedding tipis for sale – Tentipi | Published: 2026-11-02

Category: Tips & Care

Step-by-step guide to swapping a worn Kastyxa handle for the Reservskaft spare shaft, with checkpoints to keep the axe safe and ready for the next throw.

Quick answer

To replace a Kastyxa handle, remove the old shaft, fit the Reservskaft spare shaft, and secure it properly. Work slowly, check the fit at each stage, and test the axe before throwing.

Why a proper rehandle matters

A loose or cracked handle is more than a comfort issue. It changes how the axe feels in your hand and can affect control during a throw. Replacing the handle restores a solid grip and keeps the axe usable.

The Reservskaft is supplied as a spare handle for Gränsfors axes, so it is designed to match original specifications. That reduces guesswork, but the fit still depends on how carefully you install it.

When to replace instead of repair

If the shaft is only slightly dry, a light sanding and oiling may be enough. But if you see deep cracks, splinters, or a loose head that moves even after tightening, a replacement handle is the safer choice.

For throwing axes, repeated impact puts stress on the handle. A handle that has already been repaired once may not hold up as well as a fresh spare shaft.

Step-by-step handle replacement

Remove the old handle: If the handle is wedged, drill out the old wedge from the top of the eye, then push or tap the shaft out from the head. Never pry against the eye walls with a metal tool, as this can distort the head. Check the eye for burrs or debris before fitting the new handle.
Test-fit the new shaft: Slide the Reservskaft into the eye. It should seat firmly but not require excessive force. If it stops early, check for obstructions or slight oversize; do not hammer it in dry. A proper fit lets you insert the shaft most of the way by hand.
Seat the handle: Hold the head and tap the bottom of the handle on a firm surface to drive the head onto the shaft. Stop when the head is snug and the shaft protrudes slightly through the top. Avoid striking the head directly; let the handle weight do the work.
Secure the wedge: Apply wood glue to the wedge and drive it into the slot at the top of the shaft. Wipe away excess glue immediately with a damp cloth. The wedge should sit flush or slightly below the surface after driving.
Trim and finish: Once the glue is dry, cut off any protruding shaft and wedge with a fine-tooth saw, then sand flush. Apply a thin coat of oil to the handle to protect the wood. Do not sand the metal head; focus only on the wood.
Test before use: Check that the head is firmly seated and the wedge is secure. Give the handle a few firm taps on a block of wood to confirm there is no movement. If you feel any looseness, re-wedge or seek professional help before throwing.

Product facts

Reservskaft kastyxa: The Reservskaft kastyxa is a spare handle crafted for the Gränsfors axe and supplied by the Tentipi-new brand. It is intended as a direct replacement, so you can restore your axe without sourcing a custom handle.
Reservskaft kastyxa