Tentipi Mittstång 7 Pro Center Pole: Installation Tips
By Adventure tipi tents and giant hat Nordic kata wedding tipis for sale – Tentipi | Published: 2026-10-26
Category: How-to Guides
Learn how to install the Tentipi Mittstång 7 Pro center pole safely, with step-by-step guidance and common mistakes to avoid.
Quick Answer
Install the Mittstång 7 Pro by first laying the tipi flat, then raising the pole from inside, and finally securing the top pin before adjusting the base. Always keep the pole controlled and never force it into place.
Why the Mittstång 7 Pro is Different
The Mittstång 7 Pro is built for Tentipi size 7 tipis (Safir, SafirFlex, Zirkon, and Onyx). Its advanced construction is heat-treated and alloyed to be three times stronger than standard aluminum, which means it can handle heavy wind and snow loads without adding unnecessary weight. That strength also means you need to handle it with care during installation—a bent or damaged pole can compromise the entire tent structure.
Common Installation Mistakes to Avoid
One of the most frequent errors is trying to raise the pole before the tent is properly spread out and pegged. Another is pulling the pole through the top opening too aggressively, which can snag the fabric. Also, don't skip checking the pole sections for full engagement—partial connection can cause the pole to collapse under load.
Step-by-Step Installation
- Prepare the site: Choose a flat, clear area and lay the tipi out fully. Peg down the windward side and the back corners so the tent doesn't shift while you work. Common mistake: skipping the pegs can let the tent slide and misalign the pole opening. Always peg at least three points before raising the pole.
- Assemble the pole: Connect all sections of the Mittstång 7 Pro, ensuring each joint clicks or seats fully. Check that the sections are straight and free of debris. Common mistake: a partially seated joint can cause the pole to buckle later. Give each joint a slight twist to confirm it's locked.
- Insert the pole from inside: Enter the tipi and place the base of the pole on the ground near the center. Guide the top end through the top opening, using the fabric sleeve or cup if present. Common mistake: forcing the pole through the opening can tear the fabric or bend the pole tip. If the pole doesn't slide through easily, reposition the tent rather than pushing harder.
- Raise the pole: With the top end through the opening, walk the pole upright from inside, keeping your hands spaced. Use a smooth, controlled motion. Common mistake: jerking or lifting too fast can cause the pole to slip out of the opening. Have a helper outside to guide the top if possible.
- Secure the base and adjust: Once the pole is vertical, adjust the base so the pole is perpendicular to the ground (or as the tent design requires). Then tension the tent fabric around the pole and peg out the remaining corners. Common mistake: leaving the pole leaning can distort the tent shape and reduce stability. Check that the pole is centered before tensioning the fabric.
Product Fact
- Mittstång 7 Pro: The Mittstång 7 Pro uses an advanced heat-treated and alloyed construction that is three times stronger than standard aluminum while remaining lightweight. This gives you a pole that can withstand demanding conditions without adding extra weight, but it also means you should avoid over-torquing or bending it during setup to preserve its strength.
Mittstång 7 Pro
