TT Stålspik 45 Pro V: Securing a Tipi in Snow and Frozen Ground
By Adventure tipi tents and giant hat Nordic kata wedding tipis for sale – Tentipi | Published: 2026-11-05
Category: Guide pratiche
A step-by-step winter pitching routine for Tentipi tipis using TT Stålspik 45 Pro V pegs, from clearing snow to tensioning and removal in frozen ground.
Quick answer
Use TT Stålspik 45 Pro V pegs for winter tipi pitching, drive them through a cleared snow path into the ground at the correct angle, and tension the guy lines in stages. In snow or frozen ground, the peg's smooth shank and long length make it easier to set and later pull up than standard ridged pegs.
Why winter pegs differ from summer pegs
Standard ridged pegs grip loose summer soil well, but ridges can make removal difficult once frost locks around them. TT Stålspik 45 Pro V is made without ridges, so it slides out of frozen ground more easily while still holding under tension. That trade-off matters most on trips where you must strike camp in sub-zero temperatures.
Snow itself provides little holding power, so the peg must reach firm ground beneath. Clear the snow where each peg goes rather than driving through a deep drift, and expect to re-tension guy lines as the ground temperature shifts.
When this routine is the right choice
This sequence suits winter tipi pitching on snow-covered ground, frozen soil or a mix of both. It is not a substitute for proper snow anchors or deadmen in deep, loose snow where no firm layer exists. If you cannot reach firm ground with the peg, switch to a snow-specific anchoring method instead of forcing a longer stake into soft drift.
Winter tipi pitching steps with TT Stålspik 45 Pro V
- Clear snow from each peg point: Use a shovel or boot to scrape snow down to the ground at every guy-line anchor point before driving any peg. Common mistake: driving through snow so the peg never reaches firm ground. If you cannot reach firm ground, relocate the anchor point rather than adding more snow on top.
- Lay out guy lines before pegging: Spread the tipi and extend each guy line to its full length so peg positions match the final footprint. Common mistake: pegging too close to the tent, which reduces tension and leaves slack in wind. Check that all lines radiate evenly; uneven spacing puts extra load on a few pegs.
- Drive pegs at a slight angle: Drive each TT Stålspik 45 Pro V into the cleared ground at roughly 60–75 degrees, leaning away from the tent. Common mistake: hammering straight down, which gives less resistance to pull-out. Stop driving if the peg meets a solid obstruction; frozen ground can deflect a peg without visible damage.
- Tension in stages, not all at once: Tighten guy lines gradually around the tipi, then return to the first peg and re-check tension. Common mistake: over-tightening one side before the others are set, which pulls pegs loose. Leave a little slack for ground movement as temperatures drop overnight.
- Re-check after the first cold hour: Walk the perimeter after the tipi has settled and tap each peg to confirm it is still firm. Common mistake: assuming a peg that felt tight at setup will stay tight as frost grips. Carry a spare peg or two in case one works loose in soft or uneven ground.
- Remove pegs with a twisting pull: Loosen guy lines first, then twist each peg slightly while pulling upward. Common mistake: yanking straight up, which can bend the peg or strain the guy line. Clean and dry pegs before storage so ice and grit do not build up between trips.
Product facts
- TT Stålspik 45 Pro V (vinter): TT Stålspik 45 Pro V is a hard-ground winter peg made without ridges for easier removal from frozen ground. You can pitch and strike camp in cold conditions without fighting pegs that have frozen into the soil.
TT Stålspik 45 Pro V (vinter)
